Getting Started; Battery Installation - VTech Spin & Learn Ball Tower Mode D'emploi

ATTENTION :
NOTE:
Unlock the packaging locks:

GETTING STARTED

BATTERY INSTALLATION

1. Make sure the unit is turned OFF.
2. Locate the battery cover on the back of
the activity panel. Use a screwdriver to
loosen the screw.
3. Install 2 new 'AAA' (LR03/AM-4)
batteries following the diagram inside
the battery box. (The use of new alkaline
batteries is recommended for maximum
performance.).
4. Replace the battery cover and tighten
the screw to secure.
Pour la sécurité de votre enfant, débarrassez-
vous de tous les produits d'emballage tels que
rubans adhésifs, feuilles de plastique, attaches
et étiquettes. Ils ne font pas partie du jouet.
Please keep this instruction manual as it contains
important information.
Rotate the packaging locks 90 degrees
counter-clockwise.
Pull out the packaging locks.
5