Peaq PPA40BT-B Mode D'emploi page 25

All manuals and user guides at all-guides.com
• Bluetooth button:
LED flashing in red and blue: Turned
on and ready for Bluetooth
• LED shines continuously in blue:
Paired with a Bluetooth
Bluetooth
PAIRING
1. Press and hold the power button
and the Bluetooth
starts flashing in red and blue. The
speaker is ready for pairing.
2. Activate the Bluetooth
on the audio device. Connect the
Bluetooth
speaker via Bluetooth
3. A short melody will indicate that
both devices are successfully
paired. The Bluetooth
LED turns on continuously in blue.
4. Unpair at the Bluetooth
to disconnect. A sound indicates
that the Bluetooth
is deactivated. You can also long
press
_PPA40BT-B_180112_V02_HR.indb 21
®
device.
®
®
until a sound sequence rings
control LED
®
-AV-source with the
®
®
connection
®
to unpair.
Note:
• Keep both devices within the range
pairing. of 1 meter when pairing.
• Up to 10 meters reception range
while music playback via Bluetooth
• Before pairing a Bluetooth
source, refer to the AV source user
guide regarding safety instructions
and use with other devices.
MOBILE PHONE
1. To pick up an incoming call, short-
ly press
2. To end a call, press
again or end the call directly on
function
®
your mobile phone.
Note:
pairing.
Phone calls will always be the top pri-
ority. When an incoming/outgoing call
is being progressed, it actively inter-
control
®
rupts the music playback. As soon as
the call has been ended, the music
source
®
resumes.
MUSIC PLAYBACK
1. Start the music playback on the
Bluetooth
ported).
2. Press and hold the button
to skip a title forward or back.
button once.
AV source or press
®
button of the speaker (if sup-
ENGLISH
.
®
AV
®
button
or
21
12/1/18 8:15 pm