Dirna bycool DINAMIC 1.1 Manuel De L'utilisateur page 7

DINAMIC 1.1
TO ACTIVATE REMOTE CONTROL
- The equipment being switched off, keep the
flashing. Once it remains fixed, touch any key of the control and it will recognised.
C
If no control key is pushed during 30 seconds, the equipment will stop. (It is possible to
programme up to 5 controls for one single item of equipment).
TO DISABLE REMOTE CONTROL
- In order to erase any programmed control, continuously press the
C then press the
shows
All activated controls are automatically cancelled (do not wait more than 30 seconds between
pressing one key and the other or equipment will be switched off).
ca will appear on display. alternatively whith the selected temperature. If temperature is
above 32º inside vehicle, when equipment is switched on, blower and compressor go into
maximum power for about 20 minutes, then blower and compressor regulate their capacity
depending on inside temperature.
By pushing , one key or the other, desired temperature is chosen, between 15º and
27º C - 59-80º F
With this function, compressor goes into maximum power with minimum air speed.
Compressor is activated or desactivated according to temperature selected on display.
, pushed, blower speed increases and U1, U2, U3, U4, U5 appear on
By maintaining
display. Release on desired speed.
, pushed, blower speed decreases and U1, U2, U3, U4, U5 appear on
By maintaining
display. Release on desired speed.
By pushing only once, one key or the other, desired temperature is chosen, between
15º and 27º C - 59-80º F
All manuals and user guides at all-guides.com
key.
F4 Automatic functioning
F0 Manual functioning
7
Air conditioning for vehicles
plate key pressed until display shows
plate key until display
EN