1.2 WARRANTY AND AFTER SALES SUPPORT
Electa Amator III loudspeakers are designed and manufactured according to the highest quality standards.
Should however a fault or a malfunction occur, the loudspeakers are covered by warranty, in compliance
with the regulations in force in the country where the loudspeakers were purchased.
In such cases, please contact the Sonus faber dealer from whom you purchased your loudspeakers, or the
official Sonus Faber distributor for your country; the contact information for all the distributors can be found
on our website:
• https://www.sonusfaber.com/distributori-store/
• https://www.sonusfaber.com/en/distributors-stores/
The following should also be kept in mind for your convenience:
• The warranty on the loudspeakers covers any manufacturing defects;
• Keep the receipt as proof of purchase to show to the retailer if necessary;
• Keep the loudspeakers' original packaging so that they can be transported without suffering damage if
they need to be shipped to an authorised service centre;
• The loudspeakers must be accompanied by a description of the malfunction or defect encountered.
The product's warranty will be void under the following conditions:
• If the product has been disassembled or modified by persons other than a Sonus Faber authorised
service centre;
• If the product has been used in a manner that is not consistent with the indications contained within this
manual.
1.3 DECLARATION OF CONFORMITY
Sonus faber SpA with headquarter in Via Antonio Meucci, 10 - 36057 Arcugnano (VI) Italy, declare under
our sole responsibility that
to which this declaration relates is in conformity to:
Directive:
2014/30/EC (EMC) Electromagnetic compatibility.
2011/65/EU (RoHS) Restriction of the use of certain hazardous substances in electrical and electronic
equipment.
2012/19/EU (WEEE) Waste electrical and electronic equipment.
2006/1907/EC (REACH) Registration, Evaluation, Authorisation and Restriction of Chemical.
2001/95/UE (GPSD) General product safety.
Standards:
EN 62368-1:2017 Audio/video, information and communication technology equipment – Part 1: Safety
requirements.
EN 55013:2013
EN 55020:2015
EN 61000-6-1:2013
EN 61000-6-3:2012
Arcugnano, 01/08/2018
CONFORMITY WITH INTERNATIONAL STANDARDS
EN 62368-1:2014 Audio/video, information and communication technology equipment – Part 1: Safety requirements.
UL 62368-1:2014 Audio/video, information and communication technology equipment – Part 1: Safety requirements.
CAN/CSA-C22.2 NO. 62368-1-14 Audio/video, information and communication technology equipment – Part 1:
Safety requirements.
FCC Rules Code of Federal Regulations Title 47 - Telecommunications - Part 15 - Radio Frequency Devices:
Subpart B - Unintentional Radiators.
CARB California Air Resources Board: code of regulation ATCM 93120 phase 2 compliant for formaldehyde emission.
Electa Amator III
9
CEO Jeff Poggi