Wallbox Power Boost Manuel D'installation Et Guide De L'utilisateur page 24

All manuals and user guides at all-guides.com
Fig. A2.2 shows the cabling between the energy meter and the Wallbox.
The numbers are refering to the Fig. A2. 1 . Before turning on the system
it is important to check again that the connection of "GND" and "12 V"
has been done correctly.
Fig. A2.2: Cabling in Temco energy meter
In the following pages Fig. A2.3, Fig. A2.4, Fig. A2.5 and Fig. A2.6 show
where to connect the cabling to the Wallbox.
20
TEMCO
Voltage + 1
Voltage - 2
RS485 - 3
RS485 + 4
Power 5
Power + 6
Wallbox
D- (RS485B)
D+ (RS485A)
GND
12 V