Troubleshooting - Piazzetta ME Manuel D'installation, D'utilisation Et D'entretien

Kit de ventilation multifuoco avec télécomande
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

All manuals and user guides at all-guides.com

9.0 TROUBLESHOOTING

DT2011496-00
MODIFYING THE FREQUENCY CODE
In there is other equipment with the same frequency code as your remote control you can modify the broadcasting
channel as follows:
- undo the screw on the back of the cover with a philips screw driver and open the remote control.
- Position the microswitches in one of the 16 possible combinations listed below
TRANSMISSION CHANNEL COMBINATIONS
DT2032144-00
- Once again close the remote control cover.
- Remove the power supply to the remote control box disconnecting the plug or shutting off power at the general
cut-out switch for the area.
- Resupply power and within 5 seconds simultaneously press the "auto" and "+" buttons for 3 seconds (you will hear
a beep signifying that the code has been modifi ed).
THE WIRELESS CONTROL LIGHT DOES NOT TURN-ON
Check the status of the wireless's battery charge control.
In case of replacement proceed as follows: using a small Phillips-head screwdriver, remove the screws in the rear
part of the wireless control; then keeping it inverted, remove the rear shell. At this point replace it with a new, A 23
12V type, taking care not to invert the polarity (battery type and polarity are in any case also described on the wireless
control chart visible in the photo above). Then close the wireless control and dispose of the old battery throwing it in
the special containers located in the supermarkets, collection centres ecological islands, etc.
If the problem persists, contact a vendor service center.
THE WIRELESS CONTROL FUNCTIONS BUT THE RECEIVER DOES NOT RESPOND
If when pressing the wireless control light turns on but the receiver does not respond check that:
1. that electrical power plug is inserted in the electrical socket;
2. that the connectors are inserted properly;
3. the fuse in the wireless control box is in good condition, if necessary replace it with new one (T1.,6AL250V).
If the problem persists, contact a vendor service centre.
H07021580 / DT2000326 - 01
25

Publicité

Table des Matières
loading

Produits Connexes pour Piazzetta ME

Table des Matières