Technical Data - FAVORIT 35410 I Notice D'utilisation

78

Technical data

Once these checks have been carried out, switch on the appliance: the programme will
continue from the point at which it was interrupted.
If the malfunction or fault code reappears contact the Service Force Centre.
For other fault codes not described in the above chart, please contact your local Service
Force Centre, quoting the model (Mod.), product number (PNC) and serial number (S.N.).
This information can be found on the rating plate located on the side of the dishwasher
door.
So that you always have these numbers at hand, we recommend you to make a note of
them here:
Mod. : . . . . . . . . . . . . . . . . . . . . . . .
PNC :. . . . . . . . . . . . . . . . . . . . . . . .
S.N. : . . . . . . . . . . . . . . . . . . . . . . . .
The dishes are not clean
The dishes are wet and dull
There are streaks, milky spots or a bluish coating
on glasses and dishes
Water drops have dries onto glasses and dishes • Increase rinse aid dosing.
If after all these checks, the problem persists, contact your local Service Force Centre.
Technical data
Dimension
Electrical connection - Voltage
- Overall power - Fuse
Water supply pressure
Capacity
The wash results are not satisfactory
• The wrong washing programme has been se-
• The dishes are arranged in such a way as to
• The spray arms do not rotate freely due to
• The filters in the base of the washing com-
• Too little or no detergent has been used.
• Where there are limescales deposits on the
• The drain hose connection is not correct.
• The salt container cap is not properly closed.
• Rinse aid was not used.
• The rinse aid dispenser is empty.
• Decrease rinse aid dosing.
• The detergent may be the cause. Contact the
Width - height - depth (cm)
Information on the electrical connection is given on the rating
plate on the inner edge of the dishwasher's door
Minimum - Maximum (MPa)
Place settings
lected.
stop water reaching all parts of the surface.
The baskets must not be overloaded.
incorrect arrangement of the load.
partment are dirty or incorrectly positioned.
dishes; the salt container is empty or the in-
correct level of the water softener has been
set.
detergent manufacturer's consumer care line.
44,6 x 81,8-89,8 x 57,5
0,05 - 0,8
9