Getting Ready - Bissell POWERFRESH LIFT-OFF 1544 Serie Mode D'emploi

Operati s

Getting Ready

The mop pad may have already come attached
to the foot of the unit. If not, follow step 1 below.
1. Attach mop pad by setting the foot of the
unit in the mop pad, making sure the quick-grip
release tab is located in the back.
2. Fill the water tank.
a. On the side of the unit, open the Easy
Fill opening of the water tank and use the
included water cup to fill the water tank
with water. Don't overfill or water may spill
from the tank. For best results, water should
be at room temperature.
b. Close the Easy Fill opening.
NOTE: Do not use chemicals in the water tank
of your Lift-Off Steam Mop.
3. Pull and twist the Quick Release™ cord wrap
clockwise to unwrap the power cord completely
and plug into an outlet as described on the
Important Safety Instructions on page 2.
NOTE: Upon the first use of your steam mop or
first use after refilling the water tank, the pump
may make a 'knocking' sound. This is normal
and will diminish after 30 seconds.
www.BISSELL.com
6
1.
2a.
WARNING
Tinted plates on foot may get hot while steam
mop is in use. Do not touch while hot.
WARNING
Never put descaling, alcoholic, vinegar, or
detergent products into the steam cleaner, as
this may damage it or make it unsafe for use.
Tip
» Use of distilled or demineralized water is recommended
to prolong the life of your hard floor cleaner. To add
a fresh scent as you clean, try BISSELL demineralized
waters in various scents like Citrus, Eucalyptus Mint and
Spring Breeze.