auna multimedia Connect 150 Mode D'emploi page 35

No network connection
can be established.
WiFi connection cannot
be established
Wired connection cannot
be established.
No station is found
Hiss in FM mode
No stations available /burbling /
intermittent in DAB mode.
Alarm does not work.
USB driver or MP3 player
is not detected.
NetRemote does not show or con-
nect to CONNECT-150
All other undetermined
cases.
- Check the LAN cable or the WLAN function
- Try to set an IP address at the device
- Activate the DHCP function on the router and make the connection
again at the device
 $ UHZDOO LV DFWLYDWHG RQ WKH QHWZRUN
in such a way that access is possible
- Reboot the router
- Check the availability of WLAN network on the router.
- Place the device closer to the router
- Make sure the password is correct..
- Check the availability of LAN network on the access point.
- Reconnect or even replace the LAN cable.
 &KHFN WKH QHWZRUN DV ZHOO DV WKH DFFHVV SRLQW DQG UHZDOO
- The station may not be available currently, try it again later or select
another station.
- The link of the station is changed or the station no longer transmits,
ask the provider for information.
- The link of manual added station is not correct, make sure it is correct
DQG UH HQWHU
- Check/move the FM antenna
- Move the radio
- Move the radio.
- Rescan local stations only (high-strength).
- Check the local DAB coverage.
- Switch on the alarm.
- Due to the volume setting, refer to the solutions of „No sound".
- The source of alarm was set to be station but there is no network connection.
&KDQJH WKH VRXUFH RI DODUP RU UHFRQ JXUH WKH FRQQHFWLRQ
- Check if the USB driver or MP3 player is plugged properly.
- Some USB hard disks need external power supply, make sure it is
connected to the power.
 1RW DOO 03 SOD\HUV FDQ EH UHDG GLUHFWO\ RQ WKH GHYLFH
drive instead.
- Reopen the App.
- If you have several streaming from several devices at the same time, it
may cause crash, reboot CONNECT-150 and/or your device.
- CONNECT-150 may process large amount of data after a period of operation,
no matter in which mode, it will cause the system freeze or malfunction.
Reboot CONNECT-150 if necessary.
- The normal function of the product may be disturbed by strong Electro-
Magnetic Interference. If so, simply reset the product to resume normal
operation by following the instruction manual. In case the function could not
resume, please use the product in other location.
- The device may malfunction when used in areas with strong radio interfe-
rence. The device will work properly again once there is no more interfe
rence.
VHW WKH UHVSHFWLYH SURJUDP
XVH DQ 86%
35