Hints And Tips - ThermoPro TP-65 Manuel D'utilisation

Introduction
Congratulations on your purchase of the wireless indoor/outdoor
humidity and temperature monitor. You will now be able to know
the outdoor/indoor temperature and humidity while sitting inside.
EN

Hints and tips

If the receiver does not connect to the transmitter, try the
following:
Press and hold the CHANNEL/SYNC button on the base
station and then press TX button on the transmitter.
Relocate the base station and/or the remote unit until
connection is found.
Signals from other electronic devices may cause interference.
Place the base station and receiver away from these devices.
The transmitter may not function properly in extreme
temperatures due to battery power. Replace the batteries
or the unit will resume proper function in more moderate
weather.
If the base station is attached to a refrigerator or a metal
object by magnet, the transmission may be shorter. Remove
the base station from the refrigerator or the metal object or
place the base station and remote sensor as close as possible.
If the Humidity is lower than 10%, it will display LLL.
Warnings
Do not subject the unit to excessive force, shock, dust,
temperature or humidity.
Do not immerse the unit in water.
Do not remove any screws.
Do not dispose this unit in a fire. IT MAY EXPLODE.
All manuals and user guides at all-guides.com
-2-
Keep unit away from small children. The unit or parts of the
unit might be a choking hazard.
Never attempt to recharge the batteries using any other
methods.
Dispose of the unit legally and recycle when possible.
Specifications
1. 433 Mhz transmission frequency
2. Transmission range up to 200 feet in open area. (range maybe
shorter based on interference present)
3. Indoor Temperature range: -4 °F ~ 158°F (-20 °C ~ 70 °C)
4. Outdoor Temperature range: -58°F ~ 158°F (-50 °C ~ 70 °C)
5. Humidity range: 10% ~ 99%
6. Temperature tolerance: +/- 2.0 °F (+/- 1.1 °C)
7. Humidity tolerance: ±2% from 30% to 80%; ±3% below 30%
and above 80%
8. Power: 2 X AAA 1.5V for base unit and 2 X AAA 1.5V for
remote sensor
Components
1. One base station unit (Receiver)
2. One remote sensor (Transmitter)
*Although the remote sensor is designed to be rain-proof, the
remote sensor must be always placed upwards so that rain
won't get inside the sensor through the vent holes on the bottom
of the senor which functions to let the remote sensor detect the
environmental temperature and humidity more precisely and
quickly.
-3-
EN