Harmony DREAMTIME ELITE Manuel D'instructions page 21

You must remove the cup holder
before using/adjusting the UAS belt
system.
1. Loosen UAS by pressing upwards
on the UAS release button found
directly
adjuster strap while sliding the
UAS clips out from storage area
❶. For ease of installation,
extend UAS to its maximum
length. Ensure the UAS straps are
NOT twisted and that the UAS
connectors are facing down.
2. Place the booster seat flush
against a forward-facing vehicle
seat, CENTERED between the
UAS anchors.
! WARNING: When using UAS, DO
NOT place the child restraint off-
center of the vehicle anchors.
3. Fasten UAS hooks to vehicle UAS
anchors ensuring the hooks are
facing downwards ❷. Pull firmly
to be sure that they are attached.
Belts must lay flat and not be
twisted.
4. Tighten UAS by pulling on the
upfront UAS adjustment belt
while pushing the child restraint
towards the vehicle backrest ❸.
5. To loosen the UAS, press upwards
on the UAS release button and
pull child restraint forward ❹.
! WARNING: NEVER put two UAS
connectors on one vehicle UAS
anchor ❺.
under the up-front
❺
❶
❷
❸
❹
20