Using Shoulder Belt Guide - Harmony BIG BOOST DELUXE Manuel D'instructions

Booster must be level, stable and not rock side-to-
side (see "Vehicle seating positions").
2. Place child in the booster seat with child's back flat
against the vehicle seat.
3. Thread both sides of the lap belt
under BOTH armrests. Thread the
lower end of the shoulder belt
over the armrest on the buckle
side ❶. ENSURE that
the belt is snug across
the child's hips. It is
important to ensure
that any lap strap is
worn low down, so that the pelvis
is firmly engaged, just touching their thighs and is NOT
across their stomach.
4. Buckle vehicle seat belt into place. Ensure the buckle
is secure by gently pulling on it.
! BOTH SIDES OF THE LAP BELT MUST PASS UNDER
BOTH ARMRESTS, AND THE LOWER END OF THE
SHOULDER BELT MUST PASS OVER THE ARMREST
ON THE BUCKLE SIDE.
!
Any straps holding the restraint to the vehicle should
be tight, any straps restraining the child should be
adjusted to the child's body, and the straps should not
be twisted.
! THE VEHICLE'S SHOULDER BELT MUST LIE ACROSS THE
CHILD'S SHOULDER AND LAY ACROSS THE CHEST –
NOT THE FACE OR NECK. If the belt does not lie properly
across the child's shoulder and chest, the RED shoulder
belt guide ("Parts list - G") MUST be used to ensure
proper placement (see "Using shoulder belt guide").

USING SHOULDER BELT GUIDE

1. Slide the vehicle's shoulder belt into the RED shoulder
belt guide (pre-installed) ensuring it is flat. POSITION
THE SHOULDER BELT GUIDE OPENING SLOT JUST
ABOVE THE CHILD'S SHOULDER ❶❷.
21
❶