Operating Position - Yardworks RS25CCPR Manuel D'instructions

10
model numbers 060-2343-8 and 060-2344-6 | contact us: 1.866.523.5218
a WARNING: Make sure the locking/
release button is locked in the
primary hole and the knob is securely
attachments are designed to be used
in the primary hole unless otherwise
stated in the applicable attachment

OPERATING POSITION

All manuals and user guides at all-guides.com
a WARNING: Always wear eye
When operating the unit, stand as shown
and check for the following:
Do not run the engine at a higher speed
than necessary. The cutting line will cut
than full throttle. At lower speeds, there is
less engine noise and vibration. The cutting
line will last longer and will be less likely to
"weld" onto the spool.
Always release the throttle trigger and allow
the engine to return to idle speed when not
cutting.
To stop the engine:
TRIMMER LINE ADVANCE
The trimmer line will advance approximately
2 inches (5 cm) each time the bottom of the
trimmer head is tapped on the ground with
the engine running at full throttle.
maximum length allowed by the line limiter.
Always keep the shield in place when the
tool is being operated.
To advance the line:
Always tap the trimmer head on a grassy
area. Tapping on surfaces such as concrete
ricochet or be thrown into eyes and
face and cause blindness or other
Wear eye protection and heavy clothing.
Hold the trigger handle with your right
hand and the assist handle with your left
hand.
Keep the unit below waist level.
Without bending over, keep the line near
and parallel to the ground and not crowded
into the material being cut.
Release the throttle trigger.
Push and release the engine ON/STOP
switch.
Operate the engine at full throttle.
Hold the trimmer head parallel to and
above the grassy area.
Tap the bottom of the trimmer head lightly
on the ground one time. Approximately 2
inches (5 cm) of line will be advanced with
each tap.