Cleaning And Maintenance - WAGNER FURNO HEAT GUN F300 ELECTRONIC Manuel Du Propriétaire

FURNO 300
The best method of paint removal
Move the Heat Gun slowly and steadily forward at an angle to the
surface, pointing the nozzle in the direction of motion. This allows you
to scrape safely outside the hot air stream and keeps the scraper and
the scraped surface cooler.
A. Warm air preheats the
surface.
B. Paint is softened by hot air.
A + B. Deep penetration of heat
over total area.
C. Paint can be easily scraped
off as soon as it is softened
and the gun is moved
forward.
D. Stripped surface allowed to
cool.
Note: Do not use the Heat Gun on surfaces that can be damaged
by heat, such as vinyl-coated paneling, vinyl-coated siding
or vinyl-coated window frames.
When removing paint from window frames, the Heat Gun
will soften the putty. Be careful not to gouge the putty with
the scraper. The putty will firm up after it cools.
Do not use the Heat Gun on insulating laminated window
glass such as Thermopane. The glass edge expansion may
break the edge seal.
When scraping facia, do not overheat the edges of the
asphalt shingles protruding over the edge of the sheathing.
Too much heat will melt the asphalt.
A B C D
IMPORTANT: The removal of paint by a Heat Gun is safe if the
above guidelines are used, but always keep either a container of
water or an ABC fire extinguisher (suitable against Class A, B and
C type fires) within reach.

Cleaning and Maintenance

Keep the intake openings on the housing clean and free of
obstructions. Use a soft, dry brush to clean the openings periodically.
Use only mild soap and a damp cloth to clean the Heat Gun. Many
household cleaners contain chemicals which could seriously damage
the housing.
Do not use petroleum, turpentine, lacquer or paint thinner, dry
cleaning fluids or similar products when cleaning the Heat Gun.
NEVER allow any liquid to get inside the tool or immerse any part of
the tool into a liquid.
Cleaning and user maintenance shall not be made by children.
Storage
Allow the Heat Gun nozzle to cool to room temperature before
placing in storage.
The nozzle will turn dark over time because of the high heat. This is
normal and will not affect the performance or life of the unit.
EN
9