Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
until steam forms.
USING
If the label says "do not iron" or shows this icon i, fit the delicate attachment and make sure to test
•
on an inconspicuous area prior to steaming the entire garment.
•
If the label says "do not steam" or shows this icon
1.
Hang the garment in an area that will not be affected or damaged by the heat and steam, such as on
a shower curtain rail, or in an open doorway.
2.
Fit any attachment you wish to use.
3.
Plug the steamer in then press the power button. The blue power button light will slowly flash,
indicating that the steamer is heating.
4.
After about 45 seconds the power light will stay on, indicating the steamer is preheated.
5.
Prime the water pump by holding steam trigger until steam forms.
6.
To generate steam, press the steam trigger. As long as the trigger is held, steam will emit from the
steamer. When the trigger is released, the steam will stop.
•
To generate a constant flow of steam without holding the trigger, press the steam trigger and then
slide the steam trigger lock downwards. You can then release pressure on the steam trigger. To turn
the steam off, press the trigger, slide the steam trigger lock upwards, then release the trigger.
7.
With your free hand keep the fabric taut. Steam the garment with slow, downward strokes, keeping
the head of the steamer in contact with the fabric.
8.
When you have finished, press and hold the power button until the blue light goes out (about 3
seconds) and unplug.
9.
Stand the steamer on its base and allow it to completely cool off before storing. To avoid mineral
buildup, empty the tank after each use.
Using the scent infuser
The scent infuser attachment can be used to infuse your fabrics with your favourite scent.
•
The use of scents, oils, or other fragrances is at your own risk and we accept no liability. Always read
any instructions, warnings or advice regarding the use of the fragrance before using it with your
steamer. Always use the scent infuser in a well ventilated room.
•
Always remove and refit the scent infuser attachment when the steamer is cold and not producing
steam.
•
Always have the scent infuser fitted when using the delicate fabric attachment. Remove the fabric
pad if you don't want to infuse a scent to the fabric being steamed.
1.
Remove the scent infuser from the delicate fabric attachment by pulling it downwards
(Fig. D)
2.
Place a few drops of the fragrance onto the fabric pad (Fig. E). Only use the scent infuser. Do not
place fragrance directly onto the delicate fabric attachment, and never add fragrances to the water
in the water tank.
3.
Replace the scent infuser into the delicate fabric attachment.
Auto shut off
Your steamer will automatically switch to auto shut-off mode after being left inactive for 15 minutes. The
power button light will flash rapidly to indicate this. To resume steaming, press the steam trigger or power
button and wait for your steamer to fully reheat.
CARE AND MAINTENANCE
1.
Make sure steamer is off, unplugged and completely cool.
2.
Wipe all surfaces with a clean damp cloth.
3.
After the steamer has been thoroughly dried, turn it back on and lightly steam over an old cloth. This
will help remove any residue left in the steam holes.
4.
To avoid mineral buildup, empty the tank after each use.
, do not steam the garment.
m
6
Publicité
Table des Matières
