Bestway STEEL PRO 256002001312 Manuel Du Propriétaire page 9

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

INSTALLATION
Installation usually takes approximately 20-30 minutes with 2-3 people
excluding earthworks and filling.
Assembly of the Frame Pool can be completed without tools. To lengthen the
life of your pool, it is important to sprinkle the top rail with the Talcum Powder
before assembly. Talcum Powder is not included and easily available in the
market.
Bestway will not be responsible for damage caused to the pool due to
mishandling or failure to follow these instructions.
1. Lay out all parts and check that you have the correct quantities as listed in
the components list. For assistance or FAQs, please visit the support
section on our website, www.bestwaycorp.com.
2. Spread out the pool and make sure the pool is right side up; let it sit
exposed to direct sunlight for 1 hour or more so that the pool is more
flexible during set up.
3. Place the pool near an adequate drainage system to deal with overflow
water and ensure the pool's inlet A and outlet B are correctly positioned to
allow your filter pump to connect to a power source.
NOTE:
Do not use extension power cords to power your pump.
ATTENTION:
Do not drag the pool on the ground, this can
damage the pool.
NOTE:
Drawings for illustration purpose only. May not reflect actual
product. Not to scale.
1
A
A
A
A
A
A
2
A
C
3
D
F
4
A
A
A
A
A
A
A
A
A
A
A
C
C
C
C
C
C
C
C
B
E
5
CONNECTION VALVE ASSEMBLY
For pool with connection valve.
NOTE:
If you want to connect other pool cleaning kits to the pool
through the connection valve, disassemble the Debris Screen from the
Connector.
A
FILLING POOL WITH WATER
ATTENTION:
1. Fill the pool until the water reaches the welding line located 2.0in.-7.9in.
(5cm-20cm) from the top of the pool. DO NOT OVERFILL as this could
cause the pool to collapse. In times of heavy rainfall you may need to empty
some of the water to ensure the level is correct.
2. When filling the pool is completed, check that the water is not collecting on
any side to ensure the pool is level.
C
IMPORTANT:
C
C
ground by digging out. Never attempt to move the pool with water in it,
C
serious personal injury or damage to the pool may result.
WARNING:
your pool has any bulge or uneven side then the pool is not level, the sides
may burst and the water may discharge suddenly causing serious personal
injury and/or damage to property.
3. Check pool for any leaks at valves or seams, check any evident water loss.
Do not add chemicals until this has been done.
9
1in.-2in.
(2.5cm-5cm)
A
Do not leave pool unattended while filling with water.
If pool is not level, drain water and re-level
Your pool may contain a great deal of pressure. If
2.0in.-7.9in.
(5cm-20cm)
B

Publicité

Table des Matières
loading

Table des Matières