Troubleshooting - Ariston TVM 70C Manuel D'instructions

Troubleshooting

One day your dryer seems not to be working. Before you call your Service Centre (see Service), go through the
following troubleshooting suggestions:
Problem:
The dryer won't start.
It is taking a long time to dry.
Possible causes / Solution:
The plug is not plugged into the socket, or not making contact.
●
There has been a power failure.
●
The fuse has blown. Try to plug another appliance into the socket.
●
You are using an extension cord? Try to plug the dryer's power cord
●
directly into the socket.
The TIMER knob has not been set properly (see Start and Programmes).
●
The START button has not been pressed (see Start and Programmes).
●
The START button was pressed with the door open. Make sure the door is
●
closed before pressing the START button (see Start and Programmes).
! If the START button is pressed with the door open the dryer will not
start. Close the door, wait for a few seconds and then press the START
button again (see Start and Programmes).
The filter has not been cleaned (see Maintenance).
●
The temperature setting is not ideal for the type of fabric you are drying
●
(see Start and Programmes).
The correct programme has not been selected for the load (see Start
●
and Programmes).
The flexible vent tube is obstructed (see Installation).
●
The air intake vent is obstructed (see Installation).
●
The permanent ventilation flap on the storm cover is obstructed (see
●
Installation).
The items were too wet (see Laundry).
●
The dryer was overloaded (see Laundry).
●
GB
11