Troubleshooting - Stihl SEA 20.0 Notice D'emploi

17 Troubleshooting

17 Troubleshooting
17.1 Troubleshooting the Hand Vacuum or Battery
Fault LEDs on the
hand vacuum
Hand vacuum 1 LED flashing
does not start green.
when switched
on.
1 LED emits red
light.
3 LEDs flash
red.
3 LEDs light up
red.
4 LEDs
flash red.
The hand
3 LEDs light up
vacuum cuts
red.
out during ope‐
ration.
The suction 1 LED flashing
power of the green.
hand vacuum
decreases.
Hand vacuum
runtime is too
short.
0458-006-9621-B
Cause
State of charge of the
battery is too low.
The battery is too
warm or too cold.
There is a fault in the
hand vacuum.
The hand vacuum is
too warm.
There is a fault in the
battery.
No electrical contact
between hand
vacuum and battery.
The hand vacuum or
battery is damp.
The hand vacuum is
too warm.
There is an electrical
fault.
State of charge of the
battery is too low.
The container is full.
The battery is not fully
charged.
The battery service
life has been excee‐
ded.
Remedy
► Charge the battery.
► Remove the battery.
► Allow the battery to cool down or warm
up.
► Remove the battery and reinsert it.
► Switch on the hand vacuum.
► If 3 LEDs continue to flash red: Do not
use the hand vacuum and contact your
STIHL dealer for assistance.
► Remove the battery.
► Wait for the hand vacuum to cool down.
► Remove the battery.
► Clean electrical contacts in the battery
compartment.
► Insert battery.
► Switch on the hand vacuum.
► If 4 LEDs continue to flash red: Do not
use the battery; contact a STIHL authori‐
zed dealer.
► Remove the battery.
► Clean electrical contacts in the battery
compartment.
► Insert battery.
► Allow the hand vacuum or battery to dry,
18.6.
► Remove the battery.
► Wait for the hand vacuum to cool down.
► Remove battery and reinsert it.
► Switch on the hand vacuum.
► Charge the battery.
► Remove the battery.
► Empty the container.
► Clean the hand vacuum.
► Fully charge the battery.
► Replace the battery.
English
33