Télécharger Imprimer la page

Charging The Battery, Leds; Mounting The Charger On A Wall; Displaying State Of Charge - Stihl SEA 20.0 Notice D'emploi

Publicité

Les langues disponibles
  • FR

Les langues disponibles

English
► Cleaning the hand vacuum,
► Check the controls,
► If you cannot carry out these steps: Do not use
the hand vacuum and contact your STIHL
dealer for assistance.
6

Charging the Battery, LEDs

6.1
Mounting the Charger on a
Wall
The charger can be mounted on a wall.
1
2
a
b
a
Check the following points
when mounting the charger on
a wall:
– Suitable fixing materials.
– The charger is level.
The following dimensions are observed:
– a = at least 100 mm
– b = 54 mm
– c = 4.5 mm
– d = 9 mm
– e = 2.5 mm
6.2
Charging the battery
The charging time depends on various factors,
e.g. the battery temperature or the ambient tem‐
perature. For optimum performance, observe the
recommended temperature ranges,
actual charging time may vary from the charging
time indicated. The charging time is indicated at
www.stihl.com/charging-times.
The charging process starts
automatically when the mains
plug is plugged into a socket
and the battery is inserted into
the charger. The charger
switches off automatically when
the battery is fully charged.
28
15.1
10.1.
3
d
e
e
18.6. The
6 Charging the Battery, LEDs
The battery and the charger warm up during
charging.
1
3
► Insert the mains plug (5) in a convenient wall
outlet (6).
The charger (2) runs a self test. The LED (3)
glows green for about 1 second and then red
for about 1 second.
► Fit the connecting cable (4).
► Insert the battery (1) in the guides in the
charger (2) and press it home as far as stop.
The LED (3) glows or flashes green. The bat‐
tery (2) is being charged.
► When the LED (3) stops glowing: The battery
(1) is fully charged and can be taken out of the
charger (2).
► If the charger (2) is no longer required. Dis‐
connect the mains plug (5) from the wall outlet
(6).
6.3

Displaying State of Charge

1
► Insert battery.
► Press the button (1).
The LEDs emit green light for about 5 seconds
and indicate the state of charge.
► If the LED on the right flashes green: Charge
the battery.
6.4
LEDs on the hand vacuum
The LEDs can indicate the state of charge of the
battery or any faults. The LEDs can be steady
green, steady red or flashing.
If the LEDs are steady or flashing green, this
indicates the state of charge of the battery.
2
5
6
4
80-100%
60-80%
40-60%
20-40%
0-20%
0458-006-9621-B

Publicité

loading