Subsonic Filter - YORKVILLE SR 300 Manuel De L'utilisateur

SubSonic Filter

The SR300 features a specially designed subsonic filter which effectively blocks potentially
destructive energy in the band below 35 Hz while slightly enhancing the band between 40 and 70
Hz. Engaging this filter produces the perception the same "bottom end", while excessive and
possibly damaging excursions of the speaker cone are prevented. The filter provides an 12 dB/Oct
skirt below 35 Hz and 1dB boost at 50Hz. We recommend using this filter. With the filter disabled,
the SR300 is flat down to 20 Hz, and rolls off at 12dB/Oct below that.
Continuous Power: (Both Channels driven, 1 KHz, 0.1% THD)
Burst Power: (Both channels driven, 10m Sec of 1KHz, 0.1% THD)
Burst Power: (One channel driven, 10m Sec of 1KHz, 0.1% THD)
Frequency Response: ±1 dB 20Hz - 20 KHz
Hum and Noise: < -95 dB re: 150W output ( typ, unweighted, 22Hz -22KHz BW)
Distortion: (Both channels driven, -1 dBr full output, 80KHz BW)
High Pass Filter: -3dB at 35Hz, -12 dB/octave rolloff
Slew Rate: >10 V/uSec
Damping Factor: >400 (20-400Hz, 8 Ohms)
Crosstalk: < - 60 dB 1 KHz
Common Mode Rejection: - 50 dB minimum / -65 dB typical at 60 Hz
Turn On/Off transient: < 15 mW-Sec
Maximum Output Current: 10 A RMS burst, 7.5 A RMS Continuous
Power Consumption: 200 Watts (typ), 500 W (max)
Transformer: Toroidal
Protection: Current Limit, Thermal Overload
Cooling: Convection
Size: 38 cm x 48 cm x 9 cm
Weight: 23 lbs. 10.3 Kg
SPECIFICATIONS
8 Ohms 110 Watts (x2)
4 Ohms 150 Watts (x2)
8 Ohms 125 Watts (x2)
4 Ohms 195 Watts (x2)
8 Ohms 140 Watts
4 Ohms 220 Watts
±0.5 dB 20Hz - 20 KHz (typ.)
< -98 dB re: 150W output ( "A" weighting)
<0.008% THD (typ, 1 KHz 8 Ohms)
<0.03% THD
<0.01% THD
<0.1% THD
< - 50 dB 20Hz - 20 KHz
15 in x 19 in x 3.5 in
2 Rack Spaces
3
(typ, 20 Hz - 20KHz, 8 Ohms)
(typ, 1 KHz 4 Ohms)
(typ, 20 Hz - 20KHz, 4 Ohms)
(DWH)
(DWH)