Hendi 281444 Mode D'emploi page 8

Preset program mode
This microwave comes with 10 preset pro-
grams. When the microwave is in 'Ready Mode'
press one of the number keys and the micro-
wave will run the program. Below you'll find
Button
Display time
Programming
This microwave can preset up to 100 programs.
See and follow "User options - 9 Double digit"
session for setting program no. from 10 to 100.
Open the door, then press and hold number "1"
on the number keyboard for about 4 ~ 6 sec-
onds, the buzzer will sound and the display will
show "ProG" to indicate you entered program
mode. Select the time with the '
display will show "00:00", select the requested
time with the number keyboard. After that, se-
lect the power level. Press the power level but-
tons [0%/20% (defrost) /50%/70%], the display
will show the selected power. If you press again
EN
the same power level button, the power will be
back to set 100% power. Also, if no power level
button is set, the power will be default to 100%.
After setting the time, power and press the '
' button to save the program. The display will
show "ProG". Close the door to return to 'ready
mode'. If you want to cancel during program-
ming, press the ' ' button and the oven will
return to the 'door open' mode and the pro-
gram won't be saved.
Double quantity (X2)
This microwave is equipped with a function
to calculate the amount of time needed when
preparing a double quantity of food. Press the
'X2' button followed by the program and the
8
1 2 3
0:10 0:20 0:30
' button, the
the 10 preset programs. When operating the
microwave shows the remaining time in the
display, when it's a multi-stage program the
total remaining time will be displayed.
4 5 6
0:45 1:00 1:30
Below a quick guide how to make a program of
1.25 minutes at 70% power:
1) Open the door and press number button '1'
for 5 seconds, display will show "ProG".
2) Press number button '3', the program will
be saved in "3".
3) Press the number buttons '1' '2' '5' to set the
cooking time.
4) Press for the power level. The display will
show "PL7".
5) Press the ' ' button. The program is now
saved under number keyboard '3'.
To overwrite the program repeat the steps
above.
Note: Total programming time is limited to 60
minutes only.
Note: When the cooking time exceeds the max-
imum time the microwave can operate (stand-
ard 60 minutes) three beeps will be sound. This
means you need to adjust the time before the
program can work.
Note: See also = = > Return to factory settings.
microwave will increase the time you preset
and start the process. This function can only
be used in combination with a preset program
mode.
7 8 9
2:00 3:00 4:00
0
5:00