König Electronic HC-MG100 Mode D'emploi page 2

Instructions for use
* Please take out contact lenses before use.
* Please keep the soft massage feeler clean (if dirty, please wipe it with a wet cloth).
Instructions for use
Put the batteries inside the case according to the indicated polarity and close the battery cover.
1. Insert the batteries, press the "on" switch, then the product will operate normally and repeatedly from
function 1 to function 9, which are Strong massage-Moderate massage-Soft massage-Knead-Soft
knead-Moderate knead-Strong beat-Soft beat-Moderate beat.
2. If the "on/off" switch is pressed again, the massage mask will switch off.
3. If the "function code" button is pressed, it will operate according to your choice of functions from 1 to 9,
which are Strong massage-Moderate massage-Soft massage-Knead-Soft knead-Moderate knead-Strong
beat-Soft beat- Moderate beat.
4. If the "Timer" button is pressed, you can set the massage time to 3 minutes or 5 minutes.
About Nd.Magnet
Please do not use this product if:
* your eyes are injured or inflamed.
* your head has wounds.
* your eyes have burn wounds or if you just had eye surgery.
Caution:
1. People with a high level of short-sightedness should use the product with prior advice from a doctor.
2. Children under 8 years of age should use the product under adult supervision.
3. Please do not use this product after eye surgery or if your eyes are injured.
4. Please take off contact lenses before using the product.
5. Please do not use the product for more than 20 minutes at a time.
6. Please do not dismantle the rare-earth magnetic.
7. Please do not pluck the soft massage feeler.
8. Please do not use the product in the bathroom or any place with high temperatures.
9. The product is operated by 2 "AAA" batteries.
10. Always insert the batteries according to the indicated polarity.
All manuals and user guides at all-guides.com
ENGLISH
If the Nd. magnet falls from the soft massage feeler, please insert it again
(as shown in the attached illustration). PIease switch off the product before
inserting the Nd. Magnet.
2