10 ELECTRIC ICE SHAVER
with particular standards. It is advisable to pay particular attention to those
warnings highlighted with the symbol.
USAGE PRECAUTIONS
•
Before using this appliance for the first time or after a long period of disuse,
wash the shaver bowl assembly cup in warm water with dish soap, rinse
and dry thoroughly.
•
Before each use of the appliance, check that it is mechanically intact.
The motor unit, the shaver bowl assembly and the support base must not
be cracked or broken in any way. The sheath and the plug should not be
cracked or broken. However if they are, remove the plug immediately from
the socket and take the appliance to an authorized technical center for ne-
cessary repairs.
•
Before plugging in the appliance, check that the switch is not in the "On"
position.
•
Ensure that the ice shaver and the cable are not too close to the edge of the
table or work surface, that it is not touching heat sources, and that it is not
near a sink.
•
Never immerse the motor unit in water or other liquids.
•
Use ice cubes that are made from most residential ice makers. Commercial-
ly produced bagged ice may be used as long as the cubes are not too big.
•
Substances other than ice should never be placed in the container shaver
bowl assembly.
•
Never run the appliance while empty.
•
Never run the appliance before it has been correctly mounted on its base.
•
Never put your fingers into the bowl assembly because the blade is
very sharp and may cause injury.
FIGURE A - ASSEMBLY / PARTS DIAGRAM
All manuals and user guides at all-guides.com
Clear lid - A
Nut - B
Interior bowl - C
Gear hoop - D