Sub-Zero Wolf Guide D'installation page 5

I NSTAL L AT IO N
Flush Installation
To ensure a proper installation, a template for the countertop
cutout should be created using the cooktop glass.
ROUT IN G O PT IO N
For this installation, a recessed area surrounding the coun-
tertop cutout is required. Fabrication of the recessed area
must take place before the countertop is installed.
This option is not recommended for countertops with a
molded backsplash.
Sub-Zero, Sub-Zero & Design, Sub-Zero & Snowflake Design, Dual Refrigeration, The Living Kitchen, Great American Kitchens The Fine Art of Kitchen Design, Wolf, Wolf & Design, Wolf Gourmet, W & Design, red colored knobs, Cove, and Cove & Design are registered trademarks and service marks of Sub-Zero Group, Inc. and its subsidiaries.
All other trademarks are property of their respective owners in the United States and other countries.
CLEAT O PTIO N
For this installation, the countertop cutout will be the same
size as the outer edge of the cooktop glass.
Attach L-shaped cleats to the perimeter of the countertop
cutout. The top edge of the cleat can not be wider than
22 mm and will be attached 8 mm below the surface of the
countertop. Refer to the illustration below. Attach the cleats
to the countertop. Consult a countertop supplier for proper
methods of attachment.
8 mm
L-SHAPED
CLEATS
22 mm
Support cleats
Cooktop Installation
Remove the cooktop and components from the shipping
package and recycle packing materials.
Lower the cooktop into the countertop cutout. Center
1
the cooktop in the opening with the front edge aligned
parallel to the front edge of the countertop. Using a
pencil, outline the rear edge of the cooktop on the coun-
tertop. Remove the cooktop.
Apply the foam strip to the perimeter of the countertop
2
opening. Refer to the illustration below. Do not seal the
cooktop to the countertop.
Insert the cooktop into the opening. Verify the cooktop is
3
aligned with the front edge of the countertop.
Attach the brackets provided, to the bottom of the unit.
4
Insert the 89 mm clamping screws into the brackets. Use
a screwdriver to tighten the clamping screws against the
bottom of the countertop. Do not overtighten screws.
Refer to the illustration below.
FOAM STRIP
COUNTERTOP
BRACKET CLAMPING
SCREW
Cooktop installation
TRO UB L E SH OO TIN G
Troubleshooting
IMPORTANT NOTE: If the cooktop does not operate
properly, follow these troubleshooting steps:
• Verify electrical power is supplied to the cooktop.
• If the cooktop does not operate properly, contact Wolf
Factory Certified Service. Do not attempt to repair the
cooktop. Wolf is not responsible for service required to
correct a faulty installation.
wolfappliance.com
|
5