Sub-Zero Wolf Guide D'installation page 2

I NDUC TI ON C O O KT OP
Contents
Induction Cooktop
2
Specifications
2
Installation
3
Troubleshooting
5
Features and specifications are subject to change at any
time without notice.
Important Note
To ensure this product is installed and operated as safely
and efficiently as possible, take note of the following types
of highlighted information throughout this guide:
IMPORTANT NOTE highlights information that is especially
important.
CAUTION indicates a situation where minor injury or product
damage may occur if instructions are not followed.
states a hazard that may cause serious injury or
WARNING
death if precautions are not followed.
IMPORTANT NOTE: Save these instructions for the local
electrical inspector.
|
2 English
Product Information
Important product information, including the model and
serial number, are listed on the product rating plate. The
rating plate is located on the bottom of the cooktop. Refer
to the illustration below.
If service is necessary, contact Wolf Factory Certified
Service with the model and serial number.
RATING PLATE
Rating plate location
S P E CIF IC ATIO N S
Installation Requirements
A minimum height clearance of 159 mm is required from the
top of the countertop to any combustible surface directly
below the cooktop.
Clearance is required for the power inlet box located at the
right rear of the cooktop. Refer to the illustration below for
dimensions.
Refer to the illustrations on pages 3–4 for additional
minimum clearances.
WARNING
Failure to locate the cooktop without proper clearances
will result in a fire hazard.
32 mm
56
mm
38 mm
84
mm
40
mm
Power inlet box clearance
FL US H IN STA L L ATION
Contemporary induction cooktops can be mounted flush
with the top of the countertop, or as a frameless standard
installation sitting on top of the countertop surface. If the
cooktop is to be mounted flush with the countertop, a
recessed area surrounding the cooktop cutout must be
provided.
An installation kit and instructions required for a flush
installation are provided with the contemporary cooktop.
CAUTION
A flush installation is intended for granite, solid surface,
or stone countertop surfaces only.
MULTIP L E C OO K TO P S
When multiple cooktops or modules are installed side by
side, the countertop cutout width is determined by adding
the width of each unit, then subtracting 25 mm. Refer to the
illustration below.
IMPORTANT NOTE: Contemporary induction cooktops
are not designed to be installed in combination with other
cooktops.
64 mm
495 mm
CUTOUT
DEPTH
64 mm
CUTOUT WIDTH
(COMBINED WIDTH OF COOKTOPS
MINUS 25 mm)
Countertop cutout