Pattfield Ergo Tools PA-180AS Traduction De La Notice Originale page 89

CHARGE BATTERY
1 Slide the battery seat onto the battery.
Plug in the battery adaptor and check
its LED:
Green
Before charging
Red During charging
Green Fully charged
ATTACH BATTERY
1 Slide the drill driver onto the battery.
Caution! Only use the provided bat-
tery with the drill driver.
FIT BIT
1
Open the chuck ring 2
into the chuck.
Caution! Before changing bits, cen-
tre the rotation direction switch, in
order to lock the drill driver.
FIT DRILL
1
Open the chuck ring 2
into the chuck and set the torque
to drill .
Caution! Before changing drills,
centre the rotation direction switch,
in order to lock the drill driver.
ROTATION DIRECTION
1 To drive in screws or drill, set the rota-
tion direction switch to
Caution! If the drill driver is not in
use, centre the rotation direction
switch, in order to lock the drill driver.
All manuals and user guides at all-guides.com
2
2
2
until the bit fits
2
until the drill fits
ring 6
2
.
Once the battery is fully charged, press
the battery release switch 12
off the battery seat.
To release the battery, press the bat-
tery release switch 12 and slide off the
drill driver.
Fit the bit into the chuck 1
the chuck ring 2 securely. Set the de-
sired torque at the torque ring 6.
Remove the bit by opening the chuck
ring 2.
Fit the drill into the chuck 1
the chuck ring 2 securely.
Remove the drill by opening the chuck
ring 2.
To loosen screws, set the rotation di-
rection switch to
.
and slide
and tighten
and tighten
EN 87