Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Product overview
1
Chuck
2
Chuck ring
3
LED
4
On / Off switch
5
Bit holder and Bit
6
Torque ring
7
Rotation direction switch
8
Battery power check
9
Battery
10
Gear selector
11
Soft grip
12
Battery release switch
Intended Use
The tool is intended for driving in and loos-
ening screws as well as for drilling in wood,
metal, ceramic and plastic. The tool is not in-
tended for commercial use.
Any other use or modification to the tool is
considered as improper use and could cause
considerable dangers.
CHARGER SET-UP
1
Plug the battery adaptor plug into the
battery seat.
86
EN
All manuals and user guides at all-guides.com
Using the tool
1. Set the desired rotation speed on the gear
2. To switch on the tool, press the on / off
3. Make sure your workpiece can not slip.
4. To switch off the tool, release the on / off
Battery power
Press the battery power check button
check the remaining battery power:
selector 10.
1
gear Screw driving /
st
Larger diameter drilling
2
gear Smaller diameter drilling
nd
switch 4. The deeper the on / off
is pressed, the faster the drill driver ro-
tates.
Start working, while holding the tool
firmly.
switch 4.
Caution! If the drill driver is not in
use, centre the rotation direction
switch, in order to lock the drill driver.
Red, Yellow, Green
Red, Yellow
Red
2
Caution! Only use the provided bat-
tery adaptor and battery seat in or-
der to charge the battery.
switch 4
8
to
80-100 %
40-79 %
0-39 %
Publicité
Chapitres
Table des Matières
