Publicité
May we congratulate you on your new greenhouse
GB
Dear Customer!
Dear Customer!
The assembly of your new greenhouse
requires no technical knowledge. However, it
a bit of technical knowledge. However, it is
important that the assembly instructions are
packs corresponding to the order in the
corresponding to the order in the assembly
instruction. Erect one pack at a time. All nuts
components.
separate lists of components.
symbols:
All detailed illustrations are marked with
symbols:
Seen from
Seen from the outside
Seen from inside
Seen from outside.
the inside
Precautions.
•
Assembly must only be carried out in dry
•
Assembly must only be carried out in dry
and calm weather.
and calm weather.
•
Always use working gloves while glazing.
•
Always use working gloves while
Greenhouse glass has sharp edges,
glazing Greenhouse glass has sharp
especially if the glass breaks.
edges,especially if the glass breaks.
•
Assistants and especially children must be
•
Assistants and especially children must be
warned that broken glass is an element of
warned that broken glass an element of
danger. Pick up broken glass at once and
danger. Pick up broken glass at once and
remove it with care.
remove it with care.
•
We recommend to use protective glasses
•
We recommend to use pr
•
Place the l a dder on a level support.
•
Place the ladder on a level support.
•
It is essential to have an assistant.
•
References
The base is not included in this delivery.
page(s) on which the component is used.
separately. It ensures you have a stable and
Page 13:
easy to build base. If you make your own base
Foundation
the measurements indicated must be external
measurements.
However, an original base can be bought
separately. It ensures you a stable and easy to
need about 75 litres of concrete for the
build base.
fastening of the corner and middle anchors.
If you make your own base the measurements
The base must be 100% level and square; the
indicated must be external measurements.
If you buy an original base you furthermore
diagonal measurements are equal.
need about 75 litres of concrete and 6/8
plastic-/concrete pipes of about 800 mm which
are placed in a non-freezing depth for the
fastening of the corner and middle anchors.
drawing A.
latter is ensured by checking that the two
diagonal measurements are equal.
Order of assembly
Place the components as shown on the
Tools
tools shown on page 12.
has been assembled.
Page 14-27:
Place the components as shown on the
illustration and assemble in the order shown
in the pictures. Do not tighten the nuts
completely until the front gable construction
has been assembled.
Page 13:
Important before glazing!
(Fastening to the base).
Make sure that gables and sides are level and
When constructing your own base you have
square, and that door(s) and window(s) are
to drill holes (7 mm) in the ground frame
between all the vertical frames, the greenhouse
is then fastened to the base with screws (A).
Best order of assembly:
Using an original base the greenhouse is
1) Rear gable – 2) Front gable – 3) Sides –
fastened to each vertical bar as shown on
4) Frame assembly – 5) Roof and bracing 6)
drawing B/C.
Doors – 7) Vents – 8) Glazing
Page 24-27:
For an easier assembly we recommend that you
Degrease the sheets and frames with spirit.
oil the screws for the doors.
Fit glazing strip (411) to all glazing bars, gable
Fitting of glass/polycarbonate
bars and corner posts before you begin to
Important before glazing!
glaze the greenhouse.
Spring wire clips and glassholders are to be
Make sure that gables and sides are level and
square, and that door(s) and window(s) are
functioning perfectly.
X = Spring wire clips, > = Glassholders
Best order of assembly:
1) Windows – 2) Roof – 3) Doors – 4) Gables
– 5) Sides
A possible adjustment is made by means of a
Page 30-33:
NB!
Glazing (illustration 1 to 8)
polycarbonate sheets must not come into
Degrease the sheets and frames with spirit.
contact with the ground. Rest them on a piece
Start glazing from below, one glass at a time.
of cardboard.
Apply a 3 mm silicone line on the vertical
frames where indicated (dotted lines on
Sealing of the polycarbonate sheets
the illustration). (A 3 mm line of silicone is
The sheets may be sealed against insects.
tant.
you do use more than recommended, you can
buy extra tubes.
(available at your local dealer).
Spring wire clips and glassholders are to be
WATER AND CONDENSATION
X = Spring wire clips, > = Glassholders
Please note that your greenhouse is not like a
conservatory, for example, and that you should
In case of broken glass carefully pull it
therefore be aware that the greenhouse may
outwards and loosen the silicone by means of a
new pane of glass.
Page 34-37:
Mounting of polycarbonate
Now your greenhouse is completely
show where to mount the polycarbonate plates
following:
in mm. A possible adjustment is made by
Maintenance
•
Grease doors (hinges and lock or
NB! To avoid the formation of algae the
doortrack).
polycarbonate sheets must not come into
•
contact with the ground. Rest them on a piece
•
Adjustment of windows.
of cardboard.
•
Replacement of broken glass.
•
Clean the greenhouse with disinfectant
A-lists are mounted as shown on page 35/37.
Put the sheet into the bottom list, bend the
sheet slightly outwards and put it in the top list.
M-lists are mounted as shown on page 35/37.
Place the upper part of the list under the alu.
WATER AND CONDENSATION
Sealing of the polycarbonate sheets
Please note that your greenhouse is not like a
conservatory, for example, and that you should
therefore be aware that the greenhouse may
condensation out (available at your local
dealer).
Now your greenhouse is completely assembled.
However, please notice the following:
In areas with occurrence of snow we
Maintenance
•
•
•
•
•
•
•
•
•
Winter Protection
In areas with occurrence of snow we
•
recommend the following winter protection:
•
Insurance
•
Please note that not all insurance companies
•
contact your insurance company to ensure an
•
insurance coverage.
•
Guarantee
We grant a guarantee of 12 years which
covers replacement of faulty parts. The
Insurance
guarantee does not cover polycarbonate,
Please note that not all insurance companies
glass, transport, assembly, freight etc.
cover glasshouses automatically. Please
We grant a guarantee of 2 years on
contact your insurance company to ensure an
painted parts, if any. Note that marks in the
insurance coverage.
Guarantee
The guarantee is invalid if the greenhouse is
Juliana grants a guarantee of 12 years which
guarantee does not cover polycarbonate, glass,
Complaints
transport, assembly, freight etc.
All our greenhouses are built to high standards
Juliana grants a guarantee of 2 years on painted
of quality. However, should a complaint
parts, if any. Note that marks in the painting
occur please contact your dealer at once.
the greenhouse model and number of the
not assembled according to these instructions.
component.
Complaints
All our greenhouses are built to high standards
which we hope will bring you a lot of pleasure
of quality. However, should a complaint
for many years to come.
occur please contact your dealer at once.
Remember to specify the defect by indicating
the greenhouse model and number of the
component and the quality control number.
tc.
B
USA
Grease doors (hinges and lock).
Support the roof ridge at the centre of
Clean the gutter for leaves, etc.
the greenhouse.
Adjustment of windows.
Remove greater snow loads from the
Replacemen t of broken glass.
roof.
Clean the house with disinfectant before
ainst snow falling
down from for instance a tree or a roof.
Dismount the cylinders for the automa
Secure door(s) and window(s) prev
wind damage to the greenhouse.
Support the roof ridge at the centre of the
house.
Remove g reater snow loads from the roof.
Take precautions against snow falling
down from for instance a tree or a roof.
Dismount the cylinders for the automatic
window openers, if any (optional extras).
Secure door(s) and window(s) preventing
wind damage to the house.
Publicité
