Hartan Topline S Manuel D'instructions page 9

Masquer les pouces Voir aussi pour Topline S:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 13
Instructions
WARNING!
When opening out and folding down the frame and when adjusting the back-rest, pinch-points may be caused in
which fingers etc. can be trapped unless care is exercised. Ensure that your child has plenty of clearance space.
Unfolding the pram
By pushing the lock buttons 5, unfold the upper section to bring the handle in horizontal position. Pull handle 1 upwards until handle
catch 2 has engaged.
WARNING!
Before using the pram, make sure all catches are locked.
Folding the pram
Important: Swing the handlebar 1 that the white symbols on the twist grip 3 are visible from above. Turn safety lock 3 inwards to
unlock the handle and push the additional safety lock 8 to fold the pram completely. Push the lock buttons 5 and fold the handle's
upper section 1 toward the bottom.
Reversible handlebar
To reverse the handlebar, turn the twist grips 4 in the direction of the arrow.
WARNING!
When reversing the handlebar, take care that no movable parts jam the baby's limbs, or fingers, etc. Finally,
make sure the hand lebar has reengaged properly, which is indicated by a click sound.
Height adjustment of handlebar
Press the two handle-folding lock buttons 5 and bring the upper section of the handlebar 1 in the desired position.
Removing the wheels
Release the parking brake 6. To remove or replace the wheels, press button 9. If replacing
the wheel, make sure that it is correctly latched into place.
Parking brake
To lock the wheels, depress the red securing button situated at the brake lever 6 and swing
the lever down. The two toothed brake-crown wheels engage, which is indicated by a click
sound. To release the brake, swing the lever up until it snaps into place. Having parked the
pram, try to push it to check the brake.
WARNING!
Make sure the brake is always closed when placing the baby in the
carriage or taking it out of it.
Adjusting the parking brake
After prolonged use, the wheels may cause a rattling noise. You can eliminate the problem
by readjusting the setting screw 7 situated at the brake housing.
1. Apply brake.
2. Hold the lock nut and twist the set screw 7 out until the red dot is fully visible when
the brake is applied and the green dot is fully visible when it is released.
1.
Hood and safety bar
By pressing the bayonet joint 17, the hood or the safety bar can be pulled out. When inserting it, make sure
the safety bar locks into place correctly and be careful not to pinch any of the fabric parts. By pressing the
buttons 16 (done from inside), the safety bar position can be changed.
WARNING!
The hood bar of the stroller and the safety bar are
not suitable for carrying the pram.
sun canopy
The sun shade can be folded down or removed using the zipper.
Climatic zone 20
You may open the hood flap to prevent heat from accumulating.
To do so, pull the top cover up. You can fold out the sun shade 21 for
additional protection.
8
2.
7
Right
Wrong

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Topline x

Table des Matières