Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
MAINTENANCE
The V110 valve cartridge is packed with 2 O-rings (Fig. 1), independent of each other, and will remain tight for many years.
To replace the complete insert, a Service Key MT110D119 is used, or, for replacement under pressure, the Cartridge
Changer MT110C111 is available for change of complete insert without draining the system.
CARTRIDGE
UPPER O-RING
LOWER O-RING
SEAT DISC
Fig. 1.
TYPICAL INSTALLATIONS
1. Radiator with T104A control mounted on V110D
straight pattern valve body. The control head should
be mounted horizontally in a position where the air
circulation around the unit is not obstructed.
2. Radiator with T104A control mounted on V110F hor-
izontal angle pattern valve body. The control is
mounted horizontally to prevent air heated by the
hot supply pipe from affecting the internal sensor. It
is the most common replacement of hand valves.
3. Radiator with T104A control mounted on V110F hor-
izontal angle pattern valve body. Horizontal mount-
ing of the control is required to keep the internal
sensor away from heat influences. Unobstructed air
circulation around the control head is also required
for accurate regulation.
4. Radiator with T104V control mounted on V110F hor-
izontal angle pattern valve body. This control has a
tamper resistant housing and locks to the valve body
when installed. Because the sensor is internal, the
control must be mounted horizontally, with unob-
structed air circulation around the control head.
HIGH CAPACITY THERMOSTATIC RADIATOR VALVES V110D, E, F
MT110D119
M16838
3
M16836
MT110C111
1
M4631
M16834
3
M16837
2
M4632
M12935
4
62-2014EF—02
Publicité
Table des Matières
