Mounting - NEC MultiSync LCD1570NX Mode D'emploi

Mounting

Remove Monitor Stand for Mounting
To prepare the monitor for alternate mounting purposes:
1. Place hands on each side of the monitor and lift up to the highest position.
Remove the cable cover (Figure M.1).
2. Disconnect all cables.
3. Place hands on each side of the monitor and tilt the LCD Panel back 5˚
(Figure M.2).
4. Remove the hinge cover (Figure M.3).
5. Place monitor face down on a non-abrasive surface (Figure M.4).
6. Remove the 4 screws connecting the stand to the monitor (Figure M.4).
7. Lift up the stand to unlatch the lower hooks and remove the stand
(Figure M.5). The monitor is now ready for mounting in an alternate manner.
8. Connect the cables to the back of the monitor.
9. Reverse this process to reattach stand.
NOTE: Use only VESA-compatible alternative mounting method.
Handle with care when removing stand.
Figure M.1
Figure M.4
LCD1570NXmanual051105.pmd
-5˚ Tilt
Figure M.2
Highest
Stand
Position
Figure M.5
7
7
Figure M.3
5/11/05, 1:06 PM