Motorola Solutions NNTN8234 Mode D'emploi page 9

OPERATING INSTRUCTIONS
Dual-Unit Chargers are intended for use only with the
authorized Motorola Solutions batteries and power
supplies listed in Table 1, Table 2 and Table 3 on
page 4 – 6; usage with unauthorized products may
prevent proper operation.
The battery charger will accommodate a radio with an
attached battery in the front pocket, and a battery alone in the
rear pocket. To charge a battery, use the following procedure:
(Refer to Figure 1 on page 9).
1. Plug the round end of the power supply cord into the DC
Connector on the back of the charger.
2. Plug the power supply into the appropriate AC outlet. The
charger LED will blink green once to indicate a successful
power-up.
3. Insert a radio with battery, into the charger's front pocket
by:
a. aligning the groove on each side of the radio with the
corresponding raised rail on each side of the charger
pocket.
b. sliding the radio into the charger pocket, ensuring
complete contact between the charger and radio
contacts.
4. When the radio is properly seated in the pocket, the radio
display will illuminate and display the charge status.
Note: Charge new batteries overnight to ensure full charge.
To minimize charge time, it is recommended to turn the radio
OFF.
7