Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
GRINDING
1
Attach the grinding
and align it, that the operator is pro-
tected from sparking.
Caution! Make sure the tool is
switched off and unplugged.
WHEEL THICKNESS: 6 - 8 MM
3A
Install a straight grinding wheel with
the lock
nut 5
so that the flange points
towards the machine.
Press and hold the spindle lock but-
ton
3
and tighten the lock nut
the wrench.
CUTTING
1
Attach the cutting guard
and align it that the operator is protect-
ed from sparking.
Caution! Make sure the tool is
switched off and unplugged.
WHEEL THICKNESS: 2 - 4 MM
3A
Install a cutting wheel with the lock
nut
5
so that the flange points away
from the machine.
Press and hold the spindle lock but-
ton
3
and tighten the lock nut
the wrench.
ROTATE HANDLE
1
Press the rotate handle
lease the rear end of the handle.
guard A
to the tool
3B
5
with
B
to the tool
3B
5
with
button 1
to re-
2
Close the guard release lever. If the
grinding guard is not securely held in
place, the preload of the release lever
can be increased by use of the wrench.
WHEEL THICKNESS: 6 - 8 MM
Install a depressed grinding wheel with
the lock
nut 5
so that the flange points
towards the machine.
Press and hold the spindle lock but-
ton
3
and tighten the lock nut
the wrench.
2
Close the guard release lever. If the
cutting guard is not securely held in
place, the preload of the release lever
can be increased by use of the wrench.
WHEEL THICKNESS: 2 - 4 MM
Install a depressed cutting wheel with
the lock
nut 5
so that the flange points
away from the machine.
Press and hold the spindle lock but-
ton
3
and tighten the lock nut
the wrench.
2
Turn the hanlde 90° to the desired po-
sition, so that the two arrows point at
each other.
Caution! Make sure the handle is
securly locked in place.
5
with
5
with
EN
105
Publicité
Table des Matières
