Audiovox FR-1438-2 Manuel D'utilisation page 13

All manuals and user guides at all-guides.com
Troubleshooting
Problem Possible cause
No transmission Weak batteries
while pressing Incorrect battery Polarity
the PTT button
Weak or no Weak batteries
signal received Channel and privacy
code not set the same
as target transceiver
Volume level too low
PTT button inadvertently
depressed
Excessive radio interference
on a particular channel
Obstruction of radio
signal
Transceiver Batteries extremely
beeps, but will discharged
not turn on when
Power button is
pressed
Reception of CTCSS privacy mode
unwanted signals not on
Interference from
electronic devices such
as computers or TVs
Correction
Charge or replace batteries
Install the batteries in the
directions indicated by the
battery tray.
Charge or replace batteries
Adjust the transceiver's
settings to match those settings
of the target transceiver
Increase volume level
Release PTT button
Change to a different
channel
Avoid operating in or near
large buildings or vehicles
Charge or replace batteries
Turn on the CTCSS privacy
mode and set code number to
match the setting of the
target transceiver.
Turn the devices off or move
farther away from them.
13