PRO Intellect Technology CS-80E Manuel D'utilisation page 9

All manuals and user guides at all-guides.com
You can set the preset number (on the right side) with the «+10», «+», «-» buttons.
In order to preset the next denomination, press the «BTH» button several times (as needed),
and set the expected number.
- Press the «CLR» button to clear the preset number
- Press the «START/STOP» button to exit the batch counting mode
- In order to start counting, repeat the operations in Table 7.1
- When the device reaches the preset number during counting, it will stop operations.
On the left side of the display is the denomination of the coins and on the right side is the total
quantity of coins counted. When the receiving slot is full, remove the coins from the receiving
slot and then put it back into the device. After pressing the «START/STOP» button, the device
will continue counting.
Example of the Batch Counting Mode Operation
The user preset the batch counting mode for 0.2 EURO coins to 10 units.
In the hopper there are 30 coins.
1 - After counting 10 coins, the motor stops, and on the display shows the denomination and
total quantity of the counted coins as below:
At this time there are 10 coins in the receiving slot of 20 cents. Remove the coins from the
receiving slot and put the receiving slot back into the device. After this, press the
«START/STOP» button, the device continues counting.
2 - After counting 10 coins for the second time, the motor stops and the display shows the
denomination and total quantity of counted coins as below:
At this time there are 10 coins in the receiving slot of 20 cents (on the display shows the total
quantity of counted coins, when the device is in summation mode). Remove the coins from
the receiving slot and put the receiving slot back into the device. After this, press the
«START/STOP» button, the device continues counting.
3 - After counting 10 coins for the third time, the motor stops and the display shows the
denomination and total quantity of counted coins as below:
At this time there are 10 coins in the receiving slot of 20 cents (the display shows the total
quantity of counted coins when the device is in summation mode). The batch mode
operations are now finished. The device counted 30 total 20 cent coins, with each batch being
10 coins. Clear the preset number (Press «BTH» to select nominal, then press «CLR») to exit
the batch counting mode.
9