Page 1
A SMALL AMOUNT OF PANEL FLEX IS COMMON IN WOOD PRODUCTS. LES BOIS DURS VÉRITABLES ET PLACAGES DE BOIS UTILISÉS DANS LE MOBILIER BELL'O SONT NATURELLEMENT BEAUX. CERTAINES VARIATIONS DANS LE GRAIN DU BOIS SONT NORMALES ET SOUHAITABLES. VEILLER À UTILISER EXCLUSIVEMENT UNE CIRE POUR MOBILIER EN BOIS DE HAUTE QUALITÉ POUR L'ENTRETIEN DE CE MEUBLE.
Page 2
! NE PAS GRIMPER NI MARCHER SUR LE MEUBLE. ! NE PAS TAPER NI S’APPUYER SUR LES PLATEAUX. Bell'O International Corps décline toute responsabilité en cas d'assemblage non conforme aux instructions ou pour l'assemblage, l'utilisation ou la manutention incorrects de ce meuble.
Page 3
All manuals and user guides at all-guides.com PARTS LIST / NOMENCLATURE DES PIÈCES / LISTA DE PIEZAS Quantity Quantity Part / Pièce / Pieza Part / Pièce / Pieza Quantité Quantité Cantidad Cantidad 32mm 19mm 57mm FD10 25mm 13mm...
Page 4
All manuals and user guides at all-guides.com ASSEMBLY INSTRUCTIONS INSTRUCTIONS D’ASSEMBLAGE INSTRUCCIONES DE ENSAMBLAJE NOTE: 2 PEOPLE ARE RECOMMENDED TO ASSEMBLE THIS FURNITURE. THIS TABLE IS CONSTRUCTED WITH REAL WOOD VENEER. TO AVOID DAMAGE DURING ASSEMBLY, IT SHOULD BE ASSEMBLED ON A SOFT SURFACE. REMARQUE : IL EST CONSEILLÉ...
Page 5
All manuals and user guides at all-guides.com Fig. 2 2. PLACE the left & right side panels (FD6 & FD7) on their rear sides as shown. ATTACH the bottom base (FD9) to the left & right side panels (FD6 & FD7) using 32mm bolts (FDB) through lock washers (FDF), and flat washers (FDG) as shown.
Page 6
All manuals and user guides at all-guides.com Fig. 3 Fig. 3A Chart 3B / Tableau 3B / Cuadro 3B Usable Vertical Space Between the Middle Usable Vertical Space Between the Bottom Shelf Shelf and Top Shelf Support Bar and Middle Shelf Suport Bar Center Shelf Position Espace vertical utile entre le plateau du bas Espace vertical utile entre le plateau du milieu et...
Page 7
All manuals and user guides at all-guides.com Fig. 4A Fig. 4 FD10 Fig. 4B FD10 5. CAREFULLY TILT the preassembled unit upright. ATTACH the top shelf support frame (FD5) to the side panels (FD6 & FD7). For each side panel, INSERT two 13mm screws (FDA) through two lock washers (FDF) and two flat washers (FDG) as shown in Fig.
Page 8
All manuals and user guides at all-guides.com Fig. 5 9. CAREFULLY TILT the stand onto its front side and ATTACH the back panel (FD8) with two 32mm bolts (FDB), lock washers (FDF) and flat washers (FDG) through the back panel and into the prethreaded holes in the extension rods (FD3). DO NOT YET TIGHTEN FULLY.
Page 9
All manuals and user guides at all-guides.com Fig. 6 FD10 11. COVER all unused holes with decorative plastic covers (FDM). NOTE: YOU MUST MAKE SURE BOTH MIDDLE SHELF SUPPORTS (FD4 & FD10) ARE IN THE SAME HEIGHT POSITION BEFORE INSTALLING THE MIDDLE GLASS SHELF (FD2).
Page 10
All manuals and user guides at all-guides.com Fig. 7 13. CAREFULLY ATTACH the top glass shelf (FD1) to the stand. Make sure the silver discs on the underside of the top glass shelf fit securely into the holes in the rear edge of the top shelf support frame (FD5). Working from the rear, SECURE from underneath using two 13mm screws (FDA) with lock washers (FDF) and flat washers (FDG).
Page 11
This warranty gives you specific legal rights. You may also have other rights, which vary from state to state. BELL'O INTERNATIONAL CORPORATION, 711 Ginesi Drive, Morganville, NJ 07751-1235 Phone: (732) 972-1333 Fax: (732) 536-6482 Web: www.bello.com E-mail: sales@bello.com...
Garantía limitada de un (1) año Se le garantiza al comprador original este producto Bell'O International Corporation, con excepción del vidrio, durante un período de un (1) año a partir de la fecha de la compra. Se le garantiza al comprador original el vidrio durante un período de treinta (30) días a partir de la fecha de la compra. Esta garantía se limita expresamente a los productos nuevos comprados en cajas cerradas en fábrica.