Rear Panel - Dynex DX-CDRW52 Guide De L'utilisateur

All manuals and user guides at all-guides.com
DX-CDRW52.fm Page 5 Friday, April 1, 2005 4:16 PM
Features

Rear panel

Device
Configuration
Audio output
Jumper
connector
Name
Audio output Connects the CD drive to a sound card (audio input).
connector
Device Selects the device configuration. Don't use jumpers to change anything other
configuration than the device configuration. Configuration changes become valid after power
jumper is turned off, then turned back on again. Master is the factory setting.
EIDE connector Connects an IDE cable with 40-pin IDE connectors at both ends to the system
board. Before connecting, turn off the power supply.
Power connector Connects 5V/12V DC power to the drive.
Connecting or disconnecting the EIDE cable while the power is on may
damage the drive. Make sure that you turn off power before connecting or
disconnecting the cable.
Drive jumpers must be set before installing the CD-R/RW drive. Set the
jumpers at the rear panel of the drive.
Before setting the jumpers, make sure that you have turned off the com-
puter power supply.
Power Connector
IDE Connector
Features
5