13
2. Remove the air cleaner assembly (C) and disassemble.
3. Remove debris that might get into the carburetor throat
(D).
4. Remove the pre-cleaner from the air filter.
5. To loosen debris, gently tap the air filter on a hard
surface. If the air filter is dirty, replace it with a new air
filter.
6. Wash the pre-cleaner in liquid detergent and water. Then
let it thoroughly air dry. Do not lubricate the pre-cleaner.
7. Assemble the dry pre-cleaner to the air filter.
8. Install the air filter assembly.
9. Install the cover and secure with fasteners.
Air Filter Assembly (Cyclonic with pre-cleaner)
WARNING
DO NOT start or run the engine with the air cleaner
assembly or air filter removed as it is a fire hazard.
NOTICE
Do not use pressurized air or solvents to clean the filter.
Pressurized air can damage the filter and solvents will
dissolve the filter.
1. Loosen the fasteners (A, Figure 14) and remove the
cover (B).
14
2. Open the latch (C) and remove the air filter assembly
(D).
3. Remove the pre-cleaner (E) from the air filter.
4. To loosen debris, gently tap the air filter on a hard
surface. If the air filter is dirty, replace it with a new air
filter.
5. Wash the pre-cleaner in liquid detergent and water. Then
let it thoroughly air dry. Do not lubricate the pre-cleaner.
6. Assembly the dry pre-cleaner to the air filter.
7. Install the air filter assembly and close the latch.
8. Install the cover with the fasteners.
Tire Pressure Check
For correct traction and best mowing performance, make sure
that the tire inflation pressure is 12-14 psi (0,82-0,96 bar).
Refer to Tire Pressure Check in the Maintenance Schedule.
Also, see Tire Inflation Pressure in the Specifications section.
Note: The Tire Inflation Pressure can be slightly different from
the "Maximum Inflation" shown on the side of the tires.
Check the Spark Plugs
WARNING
Unintentional sparking can result in fire or electric shock.
Unintentional start-up can result in entanglement, traumatic
amputation, or laceration.
When testing for spark:
• Use approved spark plug tester.
• Do not check for spark with spark plug removed.
17