Accessories - Festo CLR−12 Notice D'utilisation

CLR−...
3. Turn the clamping finger with a spanner
wrench. The clamping finger will then be
released from the piston rod.
For counter holding, the maximum per
mitted torque on the guide sleeve must
not be exceeded (see chapter Mechanical
installation").
A suitable pull−off device must be used if
the clamping finger sticks.
Order the wearing parts as specified.
S
Always send the defective product to Festo.
S
Make sure that the CLR−... is overhauled only by our repair service.
S
The repair process calls for delicate setting work.
Please describe the fault and the operating conditions in your correspondence.
11

Accessories

Designation
Foot mounting
Flange mounting
Start−up valve
One−way flow control valve
Non−return valve
Compressed air reservoir
Proximity switch
Clamping finger
Fig. 26
32
Fig. 25
Type
HNA−...
FNC−...
HEL−.../HEM−...
GRLA−...
HGL−...
VZS−...
SME−8−.../SMT−8−...
CLR−...FS
Festo CLR−... 0507b English