Festo CLR−12 Notice D'utilisation page 22

CLR−...
Remove the packing except for the adhesive labels on the compressed air
S
connections (to prevent dirt).
It is intended that the packaging be recycled on the basis of its constituent
materials (exception: oiled paper = other waste).
Observe the ambient conditions at your
S
location.
Make sure there is a supply of correctly
S
prepared compressed air (see chapter
Technical specifications").
Use the same medium composition
S
throughout the service life of the product.
Example:
selected: non−lubricated compressed air,
continue to use: non−lubricated compressed air.
If switching from lubricated to non−lubricated compressed air:
Observe the wear of the CLR−...
S
If the service life lubrication is washed out, the CLR−... will wear considerably.
Gradually pressurise the entire system
S
until the operating pressure is reached.
This ensures that all actuator movement
is controlled.
The soft−start valve type HEL−... or
HEM−.... can be used to build up the
pressure gradually.
Use the CLR−... in its original state without undertaking any modifications.
S
22
Fig. 6
Fig. 7
Festo CLR−... 0507b English