Important - GLÄSS NOOR STEAM MODULE L Notice D'installation, Utilisation & Maintenance

EN
• If the special maintenance is not carried out by qualified
personnel.
Serial number (Figure A) to state in each intervention request.
Do not remove the sticker from the product!
Figure A
WARNING.
• Read the manual carefully in all its parts before using the
product.
• Keep this manual for further consultation.
• The manual is intended for different models and versions, so
the product may look different from the manual illustrations.
However the instructions remain unchanged.
• The company reserves the right to make any changes
considered suitable without notice or replacement.
• This product is intended only for the use for which it has been
designed. The manufacturer is not responsible for any damage
caused by improper usage.
• The product identification data (model, power, voltage,
manufacturer's name) are contained in the silver data plate
on the unit and on the warranty card. It is issued at the time
of testing.
• Make sure that the drain is always efficient.
• Ensure that the floor around the product is always dry and
clean, to avoid slips or falls entering or editing the product
itself.
• Pay maximum attention when the surrounding floor is wet,
as there will be a potentially high risk of slipping. this, mainly,
when using soaps, shampoos, clearing detergents, etc..
• Who uses a steam bath frequently should periodically undergo
medical check-ups to ensure being in a good health status
• Steam bath must not be used by people affected by weak heart
condition, inner inflammations, infectious diseases, epilepsy
and who have pacemakers.
• People affected by obesity, weak heart condition or blood
pressure disorders, circulation problems, diabetes, elderly
people or pregnant women should consult a doctor before
using the product.
• People who take medicines should consult a doctor before
using the product as some medicines may cause sleepiness,
affect heart beat, blood pressure and circulation.
• Do not use alcoholic substances, drugs or medicines before
and during the use of the product as they could cause
unconsciousness.
• This product is not intended to be used by persons (including
children) with reduced physical, sensory or mental capabilities
or lack of experience or knowledge, unless they have been
given appropriate supervision or instruction concerning use
of the appliance by a person responsible for their safety.
• WARNING: children may use the product unsupervised only
when its operation has been clearly explained to them and
they are able to use it safely while recognising the dangers
of misuse.
• When the product is not used, disconnect it completely by
turning off the double-pole switch installed on upstream the
appliance.
All measurements are in mm.
PRE-INSTALLATION REQUIREMENTS
TECHNICAL INFORMATION:
• Minimum flow pressure:
• Operating pressure:
• Recommended operating pressure:
The power supply box, to be connected to point C.P.(see Pre-
installation requirements) .
To make the electrical connection to the power supply box use
an H07 RN-F cable with diameter of 6 mm².
When making the connection to the electrical mains, a double-
pole switch must also be fitted near the appliance, upstream of
the power supply box, with contacts opening by at least 3 mm,
and suitable for 230 V voltage and an adequate disconnecting
current for the power of the installed unit.
The appliance must be connected to an electrical system
provided with a 0.03 A differential thermal breaker.
The product's supporting structure is metallic. An efficient
ground system is therefore required, with sensitivity meeting
the relevant standards.
GROUNDWIRE.
The ground wire must be connected and fixed permanently
to the electrical system.
EQUIPOTENTIAL CONNECTION.
The equipment must be connected to the equipotential
system of the room and duly fastened to its terminal to be
found in the product.
The following accessories
manufacturer) are required for installation:
a) Fittings required for the boilerdrain towards the water mains:
a Ø40 siphoned drain is recommended.
c) Fittings required for the connection of the boiler supply to the
water mains:
• coupling size ½" F.
• installation of an on/off valve is recommended.
ROUTINE AND
SPECIAL MAINTENANCE
Use a soft sponge dampened with water and non-abrasive
neutral liquid detergents
for cleaning.
After cleaning, rinse thoroughly with plenty of water to
remove all traces of detergent and dry with a soft cloth.
a :
void
– cleaning materials which contain hydrochloric acid, formic acid,
bleach or acetic acid, as they can cause considerable damage.
– synthetic fibre cloths, scouring pads, metal pads, abrasive
detergents, alcohol, acids for domestic use, acetone or other
solvents which damage the surface.
–the build-up of limescale by cleaning regularly.

IMPORTANT:

Residues of toiletries such as liquid soaps, shampoos and shower
gels, hair dyes, perfumes, aftershave and nail varnish can also
cause damage.
Rinse thoroughly with plenty of water to remove all traces
of detergent.
In case of lime deposit it is advised to use lemon juice.
Special maintenance must be carried out by qualified
personnel.
10
150 kPa (1,5 bar)
350 kPa (max 3,5 bar)
250 kPa (2,5 bar)
(not supplied by the