GLÄSS NOOR STEAM MODULE L Notice D'installation, Utilisation & Maintenance page 11

EXTRAORDINARY LIMESCALE REMOVER CYCLE TO
CLEAN THE BOILER
Once the Turkish Bath reaches 50 hours of operation, an
extraordinary cleaning cycle with a limescale remover must be
performed.
Add the descaling liquid (2.5 l, for example, a diluted solution
of citric acid. Chemical products that produce foam are
UNSUITABLE) as follows: remove the cap on the relative
container (as shown in the figure) and pour in the descaling
liquid.
Wait 60 minutes and afterwards switch on a steam cycle ( 90
min. ) so as to remove the residual deposits of descaling liquid .
ATTENTION: do not use the HAMMAM area during the rinsing
cycle.
ATTENTION: The manufacturer declines any liability due to
failure to conduct maintenance on the product.
In case of failures or malfunctioning of the product, contact
only authorised technicians to avoid losing warranty rights. The
manufacturer shall not be held responsible for any damage
caused by products that have been tampered with or repaired
wrongly.
TROUBLESHOOTING
In the event of abnormalities run the following checklist.
All electrical connection checkup must be performed by an
electrical installation technician.
If there is no response from the wall controls, check that:
- The switch is on.
- The appliance is powered. Check that the domestic power
supply is working by testing other electrical household
appliances which you know are operating correctly.
All hydraulic connection checkup must be performed by a
hydraulic installation technician.
If the product does not dispense water, check that:
- There is water in the main pipe.
- There are no impurity into the pipes that prevent normal
water flow.
If the above operations do not solve the problem, contact your
nearest service centre or the company.
FUNCTIONING
STEAM BATH FUNCTION
b
efore starting the steam bath function
doors are closed and that there isn
The monoclimate steam function can be activate by pressing
the on/off button.
The steam bath has a pre-set time of approximately 90 minutes.
To interrupt the steam function before its end press again the
on/off button.
At the end of the cycle the led flashing. Now rinse cycle and
emptying of boiler starts.
The steam outlet nozzle becomes very hot when using the
steam function!
Hot water come out of the dispenser during the steam cycle.
Do not touch the steam dispenser when it is in use or right after
turning it off.
11
EN
,
check that the cabine
'
t an excessive steam
.
losses