Installation Instructions; Part Numbers - Cequent Towing Products 36116 Mode D'emploi

Masquer les pouces

Table des Matières

Les langues disponibles

Frame

Access hole

Drilled Hole

WAGON ONLY

Qty. (2)

Carriage Bolts 1/2-13 X 1.75

Qty. (4)

Block 1/4 X 1.50 X 2.00

Qty. (4)

Conical Washer 1/2

Qty. (4)

Hex Nut 1/2-13

Qty. (2)

Hex Bolt 1/2-13 X 2.00

Qty. (6)

Block 1/4 X 1.50 X 2.00

Examine bottom of frame rails of vehicle. To allow the hitch to sit flat, any weld spatter must be removed from frame rails.

Remove all but a thin film of undercoating from attaching surfaces.

Drop 1/2 bolt with 1/4 X 1-1/2 X 2 block down thru slot at end of frame rail. It may be necessary to hold block with one hand

and bolt with other hand to work bolt down thru block and slot. Turning bolt may help.

Raise hitch into position and install conical washer and nut at rear attachment point.

Using hitch as a template, drill two holes in frame for forward attachment

Fish wire 1/2 Carriage bolt with 1/4 X 1-1/2 X 2 block thru body mount access hole into drilled hole.

Install tapered block between frame and hitch side brackets on forward attachment points as shown.

Install remaining conical washers and hex nuts.

Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to

prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working

beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.

This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5

and SAE J684.

1994, 199, 2002 & 2005 Cequent Towing Products