Installation Site - EAS ELECTRIC M-THERMAL 2 R32 BIBLOCK ETHKH100A190 Guide D'utilisation

2.2 Remove the wooden base
 Remove the 4 screws of the wooden base (Refer to Fig.2-3).
 Four people hold the sheet metal lifting machine, one of them pull the wooden base (Refer to Fig.2-4)
 Remove the 8 screws of the sheet metal and remove the sheet metal (Refer to Fig.2-5)
 Take care when lifting machine and pulling the wooden base.
Care should be taken when transporting the heat pump unit that the casing is not damaged by

impact. Do not remove the protective packaging unit until the heat pump has reached its final
location. This will help protect the structure and control panel. The heat pump unit can be transported
ONLY vertically.
 Be careful with the Installation and Operation manual and with the factory supplied accesories box
located at the top of the unit.
 Four people are required when lifting because of the heavy weight of the unit.
Fig. -

3. INSTALLATION SITE

Do not install the IDU near a bedroom;
Suggest install it in a garage, utility room, corridor, basement, or laundry room;
Be sure to adopt adequate measures to prevent the unit from being used as a shelter by small animals.
Small animals making contact with electrical parts can cause malfunction, smoke or fire. Please
instruct the customer to keep the area around the unit clean.
The equipment is not intended for use in a potentially explosive atmosphere.
Please connect the top pipe or fill the water tank immediately after removing the wooden frame, so as
not to cause the machine to tip over.
Fig. -5
WARNING
10
Fig. -4
V.2