Lpa : 94 Db(A), Kpa : 3 Db Lwa : 105 Db(A), Kwa : 3 Db; A H,B = 8,22 M/S 2 , K B = 1,5 M/S; A H,M = 6,74 M/S 2 , K M = 1,5 M/S; Gêne - Meister PS600M Traduction Du Manuel D'utilisation Original

5403120-Pendelhub_man 11.12.14 10:24 Seite 31
GB
Operating instructions & safety hints
WARNING! To reduce the risk of injury, please read the operating instruc-
tions through carefully before using the device, and then store with the
machine! When passing the device on to another user, these operating
instructions must also be included!
Contents
1 - Scope of delivery
2 - Technical information
3 - Components
4 - Correct use
5 - General safety
instructions
6 - Safety instructions
relating specifically to
the equipment
1 - Scope of delivery
• 1 Orbital Jigsaw
• 1 Saw Blade
• 1 Adjusting key
• 1 Hoover adaptor
• Operating Instructions
• Guarantee
2 - Technical information
Technical data
Power supply
Power input
Stroke rate (no-load)
Length of stroke
Diagonal cuts
Cable
Technical changes reserved.
Noise emission/vibration
L : 94 dB(A), K : 3 dB
PA PA
L : 105 dB(A), K
WA WA
All manuals and user guides at all-guides.com
Page
31
31
32
32
33
35
230 V ~ /50 Hz
600 W
-1
n = 3000 min
0
18 mm
2 x 0-45°
150 cm
: 3 dB
7 - Installation and setting
8 - Operation
9 - Mode of operation
10 - Maintenance and
environmental
protection
11 - Service instructions
2
a = 8,22 m/s , K = 1,5 m/s
h,B B
2
a = 6,74 m/s , K = 1,5 m/s
h,M M
a mit „Sawing wood";
h,B
a mit „Sawing metal sheet".
h,M
Noise/vibration information
Measuring values determined in
accordance with EN 60745.
The specified vibration emission value
was measured in accordance with a
normed test procedure and can be used
in order to compare one electrical tool
with another.
The specified vibration emission value
can also be used for an introductory
evaluation of the influence.
NOTICE! The vibration emission
value may fluctuate from the
specified value during use of the
electrical tool. These fluctuations will
depend on the way in which the tool
is used.
Page
37
37
37
38
38
2
2
31