Electrical Installation - Weka 533.2020 Instructions De Montage, D'utilisation Et D'entretien

Despite careful quality controls, chips or splinters may be found at the drill holes of the front wall boards. This may
later lead to problems when inserting the silicone cables. So, when installing each individual layer of boards, check
that the drill holes are free and sit precisely on top of each other without misalignment.
So, when installing each individual layer of boards, make sure that there is no height offset between the front, side and
rear walls. Immediately level out minor deviations that become visible inside at the cabin corners.
We recommend that you insert all silicone and sensor cables as soon as the front wall is installed (fig. 11). Once you
have ensured that the drill holes for cable routing in the front wall are free of chips, etc., it is also possible to lay them
later. The cables must be laid and the electrical connection made before the second ceiling panel is installed (fig.
30.4).
The protective strips on the edges of the sauna ceiling panels are to be removed before installation.
When laying the roof boarding of the cabin, care should be taken to ensure that the roof boards are not pressed too
tightly into each other. Subsequent swelling of the wood as a result of moisture is unavoidable.
The differing wood moisture + tolerances
in individual components may in exceptional cases lead to minor
variations in dimensions, particularly in the area
of the pediment – front or rear wall height, which
must be adjusted during installation using appropriate means
(e.g. plane).
This must be considered after installation!
In order to guarantee complete resistance to driving rain, the window and door panes are to be sealed around the
edges with transparent silicone for window construction immediately after assembly and after painting is completed.
Silicone is not included in the delivery.
Otherwise, extremely heavy rainfall may cause moisture indoors, which can lead to discolouration and damage of the
wood. The manufacturer accepts no liability for such damages; they are not eligible for compensation under the
warranty, nor are they covered by the manufacturer's warranty. In that regard, reference is once again expressly made
to our warranty conditions at this point.
With products such as bitumen roof covering, the roofing paper included serves as preliminary protection against
weathering. To ensure lasting protection, we recommend you to cover the roof with self-adhesive, aluminium-based
roofing membranes, bitumen roof shingles or EPDM film. This provides a good basis for a long life and resistance to
the influences of the weather. If this is not done, your weka product may incur damage.
Make sure that the wall boards are not rigidly connected in a vertical direction, e.g. by installing cable ducts, shelves,
trellises, etc.

Electrical installation

The electrical installation may only be carried out by an accredited electrician taking into account the VDE and EVU
guidelines.
Please find information on assembling the sauna stove and control unit in the enclosed assembly instructions.