Cleaning The Spray Arms; External Cleaning; Troubleshooting - AEG FAVORIT 88060 VI0P Notice D'utilisation

9.2 Cleaning the spray arms

Do not remove the spray arms.
If the holes in the spray arms are clog-
ged, remove remaining parts of soil with
a thin pointed object.

9.3 External cleaning

Clean the appliance with a moist soft
cloth.

10. TROUBLESHOOTING

The appliance does not start or it stops
during operation.
Before you contact the Service, refer to
the information that follows for a solu-
tion to the problem.
With some problems, the display
shows an alarm code:
•
- The appliance does not fill with
water.
Problem
You cannot activate the appli-
ance.
All manuals and user guides at all-guides.com
A1
A2
2. To disassemble the filter (A), pull
apart (A1) and (A2).
3. Remove the filter (B).
4. Wash the filters with water.
5. Before you put the filter (B) back,
make sure that there are no residues
of food or soil in or around the edge
of the sump.
6. Make sure that the filter (B) is cor-
rectly positioned under the 2 guides
(C).
7. Assemble the filter (A) and put it
back in filter (B). Turn it clockwise
until it locks.
An incorrect position of the filters
can cause bad washing results
and damage to the appliance.
Only use neutral detergents. Do not use
abrasive products, abrasive cleaning
pads or solvents.
•
- The appliance does not drain
the water.
•
- The anti-flood device is on.
WARNING!
Deactivate the appliance before
you do the checks.
Possible solution
Make sure that the mains plug is connected
to the mains socket.
Make sure that there is not a damaged fuse
in the fuse box.
ENGLISH
31