Laney DIGBETH DB500H Mode D'emploi page 9

DB200H/DB200-210 FEATURES
1
1 - FET VOLUME – Controls the level of the FET Channel. This channel offers a clean, fast
response which is articulate & punchy in the low end
2 - FET/TUBE SWITCH – Changes the selected channel between FET & TUBE.
3 - TUBE DRIVE – Sets the amount of pre-gain to the TUBE channel. At low settings the
TUBE channel will have subtle amount of overdrive adding a characteristic warm sound.
At higher settings the preamp into the TUBE channel is pushed harder, giving you more
growl and distortion.
4 - TUBE VOLUME – Controls the post-gain level of the TUBE channel. Use it in
conjunction with the TUBE drive control to get the perfect overdrive tone at the right
volume. The TUBE Volume control can also be pulled to allow MIX both the TUBE &
FET channel. This allows blending if the sonic benefits of both channels. Great for a
clean tone with a small bit of grit or a distorted tone with super punchy bass!
5 - MID MODE - A 4-position rotary switch – each position applies one of four
different pre-shaped EQ sounds. The position selected works in conjunction with the
MIDS PRESHAPE LEVEL (6) control.
Position 1 -> A narrow lower mid cut which is great for giving more definition to your
bass when playing with a drummer. Pull it back to give space to the kick & snare, bring
it up to push your bass in front of the drums.
Position 2 -> A wider mid-range control is great for bringing out the growl of you bass,
very useful to give more bite to your distorted tones, or for cutting back and increasing
mid-range clarity.
9
2 3 4
USER MANUAL EN
5
www.laney.co.uk