Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
OPERATION
Settings
3.1
Toughened safety glass plate
Material losses
!
Never operate the appliance when the toughened safety
glass is damaged.
The front of the appliance is made of 6 mm thick toughened safety
glass.
If damaged, the safety glass will shatter into many small pieces
with blunt edges to minimise any risk of injury. On very rare occa-
sions, safety glass can spontaneously break even without external
influences.
- Avoid any strain on the glass plate, e.g. caused by people or
objects leaning on it.
- When selecting an installation site, ensure that no persons or
objects can come to harm if the toughened safety glass spon-
taneously breaks.
Note
Raw mirror glass and cast glass are subject to special
manufacturing processes. Spherical or linear inclusions
and blisters due to a roll change and pattern offset cannot
be excluded and do not constitute a quality defect.
4.
Settings
CAUTION Burns
When pressing the ON/OFF switch, avoid any contact
with the potentially hot glass plate.
Note
Depending on the size and design of the appliance, it may
take some time for it to reach its operating temperature.
Note
When the appliance is first commissioned, it may give off
an odour temporarily.
f Ensure that the room is adequately ventilated (with
f
a partially open window, for example).
The ON/OFF switch is located on the outer edge of the appliance.
1 ON/OFF switch
www.stiebel-eltron.com
f Switch the appliance on or off using the ON/OFF switch.
f
After reaching the operating temperature, the appliance heats
constantly at around 100 °C.
You can operate the appliance with an optional wall mounted
room thermostat.
f Observe the operating and installation instructions of the
f
connected room thermostat.
5.
Cleaning, care and maintenance
- After it has cooled down, clean the appliance with a damp
cloth and, if necessary, commercial glass cleaner.
- Never use any abrasive or corrosive cleaning products.
6.
Troubleshooting
Problem
The appliance
does not heat
up.
If you cannot remedy the fault, notify your qualified contractor.
To facilitate and speed up your request, provide the number from
the type plate (000000-0000-000000).
1
Cause
Remedy
Fuse or safety switch has
Check the respective fuses and
blown/tripped.
safety switches.
Remove the cause.
Overheating. The high
Remove the cause. The appliance
limit safety cut-out has
restarts after it has cooled down
tripped.
for a few minutes.
RHB, RHW, RHM |
15
Publicité
Chapitres
Table des Matières
Dépannage
