Table des Matières
Publicité
All manuals and user guides at all-guides.com
Release of the fabric
Set the needle at the highest position by turning the hand wheel (no. 11) anticlockwise.
Raise the presser foot (no. 8) and remove the fabric backwards.
Cut the threads by using the thread cutter (no. 6) at the side of the machine.
Straight and other stitching
There are three kinds of straight stitches for your choise. Turn the pattern selector (no. 4) to
the one you need. Set the needle at the highest position by turning hand wheel anticlockwise.
Gently pull both threads (about 10 cm) towards rear, raise the presser foot (no. 8), place the
fabric under the presser foot. Gently press down the foot pedal (no. 16) to start sewing. Guide
fabric gently by hand. Stop the needle in its top position, and thread can be pulled out easily.
Raise the presser foot (no. 8) and remove the fabric. This is for all the patterns of your choise.
Notice:
When turning the pattern selector, assure the needle tip is at the upper position, otherwise it
will be bent or damaged or fail to sewing.
When selecting the pattern, set the position correctly, otherwise it will hurt the needle or sew
over the the selected stitch trace. It will be different from the selected pattern.
Thread tension adjustment
For a correct stitch the upper and the lower thread should be even. By turning the thread
tension dial the upper thread can be switched from the left to the right. Use this dial to get the
two threads even.
19
Publicité
Table des Matières
